TP-LINK TL-SG1024 Guía de usuario

User Guide TL-SG1008 8-Port Gigabit Switch TL-SG1016D 16-Port Gigabit Switch TL-SG1024D 24-Port Gigabit Switch Rev: 2.0.1 7106503502

6 1) Secure the supplied rack-mounting brackets to each side of the Switch with supplied screws, as illustrated in the following figure. Figure 3-2

7 3.3 Connect to Ground Connecting the Switch to ground is to quickly release the lightning over-voltage and over-current of the Switch, which is al

8 Figure 3-5 * The figure is to illustrate the application and principle. The power plug you get from the package and the socket in your situation w

9 Appendix A: Specifications General Standards IEEE802.3 10Base-T IEEE802.3u 100Base-TX IEEE802.3ab 1000Base-T Topology Star Protocol CSMA/CD Ethern

10 Environmental and Physical Operating Temperature 0℃~40℃ (32℉~104℉) Storage Temperature -40℃~70℃ (-40℉~158℉) Operating Humidity 10%~90% non-conden

11 Appendix B: Troubleshooting 1. The Power LED is not lit ¾ Make sure the AC power cord connected the Switch with power source properly. ¾ Make

I COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Othe

II FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rul

III CONTENTS Package Contents... 1

1 Package Contents The following contents should be found in your package: ¾ One TL-SG1008/TL-SG1016D/TL-SG1024D Switch ¾ One power cord ¾ This Use

2 Chapter 1 Product Introduction This chapter describes the features of the TL-SG1008/TL-SG1016D/TL-SG1024D Switch. 1.1 Product Overview The TL-SG1

3 Chapter 2 Identifying External Components This Chapter describes the front panel, rear panel and LED indicators of the Switch. TL-SG1008/TL-SG1016

4 cable of AC cord or with Ground Cable. For detail information, please refer to section 3.3 Connect to Ground. ¾ AC Power Socket: Connect the femal

5 Caution: Please unplug the power cord before installing or removing the Switch. 3.2.1 Desktop Installation To install the Switch on the desktop