TP-LINK 54Mbps High Power Wireless Access Point Especificaciones descargar pdf (Pagina 19)

Figure 3-9 Quick Setup - Static IP

)

Note:

The IP parameters should have been provided by your ISP.

¾ IP Address - This is the WAN IP address as seen by external users on the Internet

(including your ISP). Enter the IP address into the field.

¾ Subnet Mask - The Subnet Mask is used for the WAN IP address, it is usually

255.255.255.0

¾ Default Gateway - Enter the gateway IP address into the box if required.

¾ Primary DNS - Enter the DNS Server IP address into the boxes if required.

¾ Secondary DNS - If your ISP provides another DNS server, enter it into this field.

3. After you complete the above, click Next, the Wireless settings page will appear below.

Figure 3-10 Quick Setup - Wireless settings

On this page, you can configure the following wireless parameters:

)

Note:

The Quick Setup - Wireless page differs in different modes. If you choose the AP Router mode,

you will see the Wireless page as below

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 103 104

Sin comentarios

TP-LINK 54Mbps High Power Wireless Access Point Especificaciones Pagina 19