TP-LINK 54Mbps High Power Wireless Access Point Especificaciones descargar pdf (Pagina 91)

administrator Username and Password under Advance options to get a precise estimation if the

remote device is TL-WA5110G too.

Figure 5-29 Speed Test

¾ Destination IP: The Remote device’s IP address.

¾ Advanced options: This is switch to show advanced test options which are used only for

precise estimation.

¾ User: Administrator password of the remote device. It should be filled correctly if you want to

get a precise estimation. Otherwise, keep if clean.

)

Note:

If either User or Password is incorrect, we will take a basic test instead. In other words, none of

the advance options you set will take effect.

¾ Direction: There are 3 options available for the traffic direction while estimating the

throughput.

z transmit-Estimate the outgoing throughput (TX).

z receive- Estimate the ingoing throughput (RX).

z both- Estimate the incoming (RX) first and then the outgoing (TX) afterwards.

¾ Duration: The value you specify here indicate how much time the test should last.

¾ Data amount: The maximal data amount to be sent out during the whole test.

)

Note:

If both Duration and Data amount are specified, the test will stop after any of them is met.

Be sure to click the Run Test button to start a new test after you filled enough information. You

can also stop a running test by click Stop Test button at any time.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 103 104

Sin comentarios

TP-LINK 54Mbps High Power Wireless Access Point Especificaciones Pagina 91