TP-LINK CPE510 Guía de usuario descargar pdf (Pagina 44)

Chapter 5 Network Tab

the Idle Time field. Users those pay by time for their Internet access can

choose this mode to save their Internet-access fee.

NOTE: Sometimes the connection cannot be disconnected although you specify

a time to Idle Time (0~99 minutes) because some applications visit the Internet

continually in the background.

 Automatic - Connect automatically after the device is disconnected. Users

those are charged a flat monthly fee can choose this mode.

 Time-based -

You can configure the device to make it connect or disconnect

based on time. Enter the start time in From (HH:MM) for connecting and end

time in To (HH:MM) for disconnecting. Users those need to control the time

period of Internet access can choose this mode.

 Manual -

You can configure the device to make it connect or disconnect

manually. After a specified period of inactivity (Idle Time), the device will

disconnect your Internet connection, and you must click Connect manually to

access the Internet again. If your Internet connection is expected to remain

active all the times, enter 0 in the Idle Time field. Otherwise, enter the desired

Idle Time in minutes you wish to use. Users those pay by time for their

Internet access can choose this mode to save their Internet-access fee.

Secondary Connection

If your ISP provides an extra Connection type such as Dynamic/Static IP to

connect to a local area network, you can activate this secondary connection.

 Disable -

The Secondary Connection is disabled by default, so there is PPPoE

connection only. This is recommended.

 Dynamic IP - Use dynamic IP addres

s to connect to the local area network

provided by ISP.

 Static IP -

Use static IP address to connect to the local area network provided

by ISP.

MTU Size

The default MTU (Maximum Transmission Unit) size is 1480 bytes, which is usually

appropriate. For some ISPs, you need modify the MTU. This should not be done

unless your ISP told you to.

Service Name/AC Name

Do not change it unless your ISP told you to.

Detect Interval

The default value is 0. You can input the value between 0 and 120. The device will

det

ect Access Concentrator online every interval seconds. If the value is 0, it

means not detecting.

- 41 -

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 94 95

Comentarios a estos manuales

Sin comentarios

TP-LINK CPE510 Guía de usuario Pagina 44

Comentarios a estos manuales

Relacionado con productos y manuales para Puntos de acceso wlan TP-LINK CPE510