TP-LINK CPE510 Guía de usuario descargar pdf (Pagina 62)

Chapter 6 Wireless Tab

Max TX Rate

Set the maximum transmit data rate.

Channel/Frequency

elect the channel used by this device to improve wireless performance.

1/2412MHz refers to Channel 1 and the frequency is 2412MHz. This setting is

only available in the modes of Access Point and AP Router.

CPE210/CPE220/BS210/OAP210 is a device with a frequency of 2.4GHz and

CPE510/CPE520

/BS510 has a frequency of 5GHz. The channel number varies in

different regions. We highly recommend you use the Spectrum Analysis tool to

select a proper channel.

Antenna Gain

Antenna Gain is only available in the page of BS210/BS510/OAP210. Enter the

antenna gain value according to the antennas and the value ranges from 0 to

30dBi.

DFS

DFS is only available in devices working in 5GHz including CPE510, CPE520 and

BS510.

Dynamic Frequency Selection (DFS) is used for radar avoidance and is supported

by the novel IEEE 802.11h wireless local area network standard

. Incorrect

settings may violate local regulations. It is recommended to enable the function

and choose Auto in the Channel/Frequency.

If the selected channel is DFS

channel, the device will start radar detection and avoid the channel used by

radar. If other channel is selected, there is no need to detect.

Transmit Power

You can

use the slider or manually enter the transmit power value. The

maximum transmit power may vary among different countries or regions.

NOTE: In most cases, it is unnecessary to select maximum transmit power.

Selecting larger transmit power than needed may ca

use interference to

neighborhood. Also it consumes more power and will reduce longevity of the

device. Select a certain transmit power is enough

to achieve the best

performance. You can use the Speed Test tool to find the best performance.

MAXtream

This setting is only available in the modes of Access Point and AP Router.

MAXtream is a proprietary technology of TP-LINK for Wi-Fi system. It is based on

TDMA (Time Division Multiple Access) so that data streams are transmitted in

strict order. MAXtream

aims to maximize throughput and minimize latency

especially in a multi-STAs circumstance. "Hidden nodes” problem can also be

eliminated with MAXtream enabled. W

e highly recommend you turn on

MAXtream in a large scale wireless deployment to achieve better performance.

- 59 -

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 94 95

Comentarios a estos manuales

Sin comentarios

TP-LINK CPE510 Guía de usuario Pagina 62

Comentarios a estos manuales

Relacionado con productos y manuales para Puntos de acceso wlan TP-LINK CPE510